Flying Voice Technology IP542N - Installing; Assembling the Phone; Mounting the Phone to the Wall; Turning on the Phone

FLYINGVOICE Page
7
of
72
2 Installing
2.1 Assembling the Phone
Step 1.Plug one end of the coiled phone cord into the left side of the phone base.
Step 2.Plug the other end of the handset cord into the jack at the bottom of the handset.
Step 3.If you are using an external power source, push the power cord into the power supply, and plug the power supply into the phone base unit.
Note: Use only the power supply that came with the phone.
2.2 Mounting the Phone to the Wall
Step 1.Complete the assembly instructions.
Step 2.Attach two appropriate screws to the wall. Leave 1/4 distance from the wall. This allows you to slide the mounting brackets on to the
screws. Push down slightly to lock the phone in place.
2.3 Turning on the Phone
This section assumes that the correct connections have been made.
Step 1.Plug the AC power adapter into the electrical outlet.
Note: Use only the adapter that came with the phone.
Step 2.The LCD will firstly display “Welcome, initializing…..” and all of the lights on the phone will flash.
Step 3.Next, the LCD will display “Initializing Network”.
Step 4.After the sequence, the phone will display the Internet port IP address (if IP542N can connect to the Internet), date & time, lines status for
the phone, and IP542N is started normally.
Note: If the phone does not provide this screen, re-confirm installation and connections. If these are incorrect, try unplugging the
phone and plugging it back in again. If you still don’t see the display, then contact your Phone Administrator or service provider.