Flying Voice Technology IP542N - Connect to the Internet

FLYINGVOICE Page
8
of
72
2.4 Connect to the Internet
You can connect the IP542N to the Internet via wired and via wireless.
2.4.1 Via Wired
Step 1.Check IP542N have powered on correctly.
Step 2.Plug the Ethernet cable into Internet port in the rear side of the base station. Plug the other end of the Ethernet cable into your already
prepared network connection.
Step 3.After the sequence, the IP Address of Internet port will appear at the bottom of the LCD.
2.4.2 Via Wireless
You can configuration wireless from LCD menu and from webpage.
From LCD menu:
Step 1.Press the Menu button, and then select 13Wireless using the UP and DOWN button.
Step 2.Choose 2Wireless Connection and you can view the wireless then IP542N can connect to.
Step 3.Highlight one network using the UP and DOWN button, and press the softkey button under link to connect.
Note: If the Wi-Fi need authentication, choose the authentication and fill in the password.
Step 4.Press the softkey button under ok to confirm connecting.
Step 5.If the AP has connected, the wireless icon in LCD will display linked.
From webpage:
Step 1.Login the web and then open Network/Wireless webpage.