FRÄNKISCHE DATALIGHT - 5 Simple Network Management Protocol; 5.1 Simple Network Management Protocol (SNMP)

5 Simple Network Management Protocol
5.1 Simple Network Management Protocol (SNMP)
With this switch it is possible to configure the Simple Network Management protocol (SMNP)
to send messages to an SNMP manager / trap receiver.
The community configuration for the SNMP can be done in the SNMP > Communities menu.
Figure 44: SNMP Communities page
With a click on “Add” a new entry can be made. Enter the IP Address of the SNMP Management Station or allow all
Management Stations of the chosen Community String. Choose the rights for the Community.
Figure 45: SNMP Community Popup
With a click on “Apply” the entry can be seen in the Community Table.
Figure 46: SNMP Communities page with test community
DATALIGHT Switch 12+4-Port 1000
24