PRELIMINARY INSPECTIONS
What’s in the Box
12
PRELIMINARY INSPECTIONS
What’s in the Box
1. Variable Frequency Drive (VFD)
2. Pressure Transducer
3. Transducer Cable
4. Screwdriver/Adjustment Tool
5. Strain Relief Fitting
6. Installation Guide
Unpacking and Inspection
1. Inspect exterior of package for shipping damage. If there is damage, notify the shipping agent
and your sales representative.
2. Verify the part number and product ratings on the identification label are correct.
3. Remove VFD from the box and check for damage.
4. Remove the VFD cover and check part number, current rating, and nominal voltage on the
s
ticker attached to the side of the VFD. Make sure the electrical and environmental ratings are
correct and adequate for the application.
To Next Page
