Fluids and Lubricants
Type Approved Fluid or Lubricant
Engine Oil
*
Engines compliant with EPA07 or newer regulations: Engine lube oil with a sulfated ash level less
than 1.0 wt %; currently referred to as CJ-4 oil.
Fuel
†
Engines compliant with EPA07 or newer regulations: Ultralow-sulfur diesel (ULSD) with 15 ppm
sulfur content or less, based on ASTM D2622 test procedure.
Power Steering Fluid ATF must meet TES 389 or Dexron III specifications
Hydraulic Clutch Fluid DOT 4
Manual Transmission
Lubricant
‡§
MobilTrans SHC 50 (RN 2952 E-5), SAE 50W
Synthetic transmission lubricant approved by Eaton, SAE 50W
Antifreeze
Caterpillar Diesel Engine Antifreeze/Coolant. Contains supplement additives. Available as a
premixed solution.
Detroit
™
Power Cool, premixed solution with supplement additives.
Old World Industries, Fleet Charge
™
, with supplement additives.
Drive Axle Lubricant
Recommended SAE Viscosity Grade Ambient Temperature Range
75W –40°F to –15°F (–40°C to –26°C)
75W—80 –40°F to 80°F (–40°C to 27°C)
75W—90 –40°F to 100°F (–40°C to 38°C)
75W—140 –40°F and above (–40°C and above)
80W—90 –15°F to 100°F (–26°C to 38°C)
80W—140 10°F and above (–12°C and above)
*
See the engine manufacturer’s manual for specifications.
†
See the engine manufacturer’s manual for specifications.
‡
Do not mix types or brands of fluid. Multi-weight and extreme-pressure gear fluids are not recommended.
§
Call 1-800-826-4357 for a complete list of Eaton approved lubricants.
Table 26.9, Approved Fluids and Lubricants
Specifications
26.4
To Next Page
Loading...
