Frick QUANTUM 4 - Ram Dbs Motor Starter; Oil Setpoints; Main Oil Injection; Liquid Injection

S90-010 M FRICK

QUANTUM™ COMPRESSOR CONTROL PANEL
Page 54 MAINTENANCE
RAM DBS MOTOR STARTER
setting default range
Locked Rotor Current ______ 0.0% FLA 300 - 800% FLA
Stall Time ______ 0 sec. 0 - 60 sec.
Jam Current Level ______ 0.0% FLA 100 - 600% FLA
Jam Run Delay ______ 0 sec. 0 - 60 sec.
Service Factor ______ 0.0% FLA 75 - 125% FLA
Cur. Unbalance Alarm Level ______ 0.0% FLA 2.0 - 25% FLA
Cur. Unbalance Alarm Delay ______ 0 sec. 0 - 240 sec.
RTD Temperature Alarm Level ______ 32.0° F 32 - 500° F
RTD Temperature Trip Level ______ 32.0° F 32 - 500° F
OIL SETPOINTS
setting default range
Low Oil Separator Temp Alarm ______ 55°F 49 - 100°F
Low Oil Separator Temp Alarm Delay ______ 5 sec. 0 - 300 sec.
Low Oil Separator Temp Shutdown ______ 49°F 49 - 100°F
Low Oil Separator Temp Shutdown Delay ______ 5 sec. 0 - 300 sec.
Oil Heater Off Above: ______ 122°F 100 - 150°F
High Oil Temp Alarm ______ 158°F 100 - 230°F
High Oil Temp Alarm Delay ______ 5 sec. 0 - 60 sec.
High Oil Temp Shutdown ______ 167°F 100 - 230°F
High Oil Temp Shutdown Delay ______ 5 sec. 0 - 60 sec.
Low Oil Temp Alarm ______ 55°F 49 - 100 °F
Low Oil Temp Alarm Delay ______ 5 sec. 0 - 600 sec.
Low Oil Temp Shutdown ______ 49°F 49 - 100°F
Low Oil Temp Shutdown Delay ______ 5 sec. 0 - 600 sec.
MAIN OIL INJECTION
On at Discharge Temp.
(32 – 212 deg.F) default 150
delay (0-300 sec) default 5
LIQUID INJECTION
On at Oil Temp.
(100 – 150 deg.F) default 122
delay (0-300 sec) default 5
FILTER PRESSURE SETPOINTS
setting default range
High Filter Pressure Alarm ______ 25 psig 0 - 60 psig
High Filter Pressure Alarm Delay ______ 10 min. 0 - 5 min.
High Filter Pressure Shutdown ______ 30 psig 0 - 60 psig
High Filter Pressure Shutdown Delay ______ 15 min. 0 - 5 min.