33
EN
Transport
Transport The inverter weighs approx. 806 kg and can be transported as follows:
- by its lifting eyes, e.g. using a crane or other suitable lifting gear and tackle
- by its forklift truck receptacle, e.g. using a forklift truck, lift truck or crane in conjunction
with pallet forks
Transporting by
its lifting eyes us-
ing a crane
Transporting by its lifting eyes using a crane is only possible, when the exhaust air hood is
dismantled .
Transporting by
crane using pallet
fork
Remove the front and rear base covers from on the inverter before transporting it using a
pallet fork, forklift truck or lift truck.
WARNING! Falling equipment can cause serious or even fatal injury. When
transporting the inverter using a crane
- always use all four of the lifting eyes provided for this purpose,
- the length of the lifting tackle (chain, rope, strap, etc.) must be chosen so that
the angle between the lifting tackle and the horizontal is at least 60°.
min. 60°
WARNING! Falling equipment can cause serious or even fatal injury. When
transporting the inverter using a crane and pallet fork
- the pallet fork must have a headroom of at least 1950 mm
- always insert the pallet fork into the forklift truck receptacle
- always insert the pallet fork completely into the forklift truck receptacle
- secure the inverter to prevent it slipping off the pallet fork
To Next Page
Loading...
