Fronius FlexTrack 45 - Page 28

28
Remote control
elements
(continued)
(6) Traversing direction
Selects the traversing direction.
(7) Travel speed
Regulates the travel speed of the welding carriage.
(8) Welding mode
3 welding modes can be selected:
- Test
- Without arc (O)
- With arc (I)
(9) White symbols: Weaving mode
Four weaving modes can be selected:
- No weaving
- Trapezoidal weaving
- Box weaving
- Triangular weaving
Green marking: Preset path measurement
Preset to select the additional path measurement function (green symbol) on the
weaving path button (10).
Yellow marking: Preset segment welding
Preset to select the additional segment welding function (orange symbols).
IMPORTANT! The welding process cannot start until the weaving mode adjusting
knob (9) is set to one of the white function parameters.
(10) White symbol: Weaving path
Regulates the weaving path.
Green symbol: Total welding path
Total welding path in [cm].
(11) White symbol: End-crater lling time
Enables the weld seam to be nished smoothly.
IMPORTANT: Parameters must be entered via the power source and must be
either equal to or greater than the power source value.
Yellow symbol: Start-up delay / Flying-start
If value is positive – start-up delay [s]: Start welding -> Dwell time elapses ->
Carriage starts to move.
If value is negative – ying-start [s]: Carriage starts to move. The arc does not
ignite until the “ying start” time has expired.