51
Disengaging the
welding carriage
To attain optimum wirefeed, observe the following when laying the hosepack:
- Do not kink the hosepack
- Always lay the hosepack as straight as possible
1. Undo the knurled screw (a) on the
clamp.
2. Insert the hose pack as illustrated
IMPORTANT! Do not kink the hosepack. This can cause wirefeed problems.
3. Tighten the knurled screw (a)
NOTE! Observe the maximum tensile load on the hosepack holder (see the
"Technical data" section). This value must not be exceeded.
(a)
To Next Page
Loading...
