57
Saving a program
Before saving a program:
Set the toggle switch for the "Change direction/stop" limit switch
functions to the lower position (change direction).
TEST
Set the welding mode toggle switch to the 0 position.
Set the traversing direction toggle switch to the central position 0.
Saving a program:
- Press the travel speed knob and end-crater lling time knob at the same time and
hold for 4 seconds.
- memX appears on the display. X stands for the program number that has not yet
been selected.
- Turn the travel speed knob to select the program number required.
- Press the travel speed knob to save the program with this number.
To Next Page
Loading...
