56
Additional function - path measurement:
1. Set the weaving mode knob to the GREEN marking.
2. Turn the weaving path knob and set the welding path required.
3. Turn the knob back to the white function parameter required.
Additional function - segment welding:
1. Set the weaving mode knob to the YELLOW marking.
2. Set the segment welding function parameter:
Start-up delay / ying-start:
If value is positive – start-up delay [s]: Start welding -> Dwell
time elapses -> Carriage starts to move.
If value is negative – ying-start [s]: Carriage starts to move.
The arc does not ignite until the “ying start” time has expired.
Return travel path:
Return time at the end of the welding path.
Segment path with welding:
Length of the individual welding segments.
Segment path without welding:
Length of the distances between the individual welding seg-
ments.
Selecting
additional
functions
IMPORTANT! After adjusting settings for the additional functions, turn the weaving mode
knob (1) back to the weaving mode required (white markings), otherwise the welding
process cannot start.
To Next Page
Loading...
