Fronius FlexTrack 45 - Loading a Welding Program; Changing the Units of Measurement

58
Changing the
units of
measurement
Measurements can be displayed in either metric (cm) or imperial (inch) units.
To change the units, proceed as follows:
- Set the main switch on the control box to 0 (off).
- Press and hold the left and right dwell time buttons at the same time.
- Switch on the main switch on the control box. The unit of measurement selected (cm
or inch) is shown on the display.
- Select the setting required using the travel speed knob.
- Press the travel speed knob once to conrm and apply the setting.
Loading a
welding program
To load a saved program, "mem" and the number of the last used program must be
shown on the display.
NOTE! The remote control has a factory-saved, read-only program "mem0",
which contains the working parameters for the welding carriage and oscillation
unit.
The value “mem0” cannot be overwritten.
TEST
Set the welding mode toggle switch to the 0 position.
Set the traversing direction toggle switch to the central position 0.
Set the change direction/stop toggle switch to the change direction
position.
Press the travel speed button and the weaving path / total
welding path button at the same time for at least 4 seconds.
Turn the travel speed button to select a program.
To load the program selected, press the travel speed button briey
once.