Fronius FlexTrack 45 - Maintenance intervals and procedures

65
Item Component Procedure Interval
A
Linear guides Clean, check oil lm M
B
Gearbox Clean, regrease M
C
Rack and pinion Clean, regrease M
D
Rollers, underbody & rails Clean, check position M
E
Safety devices:
- Limit switch
Function test D
F
Grease nipples Regrease M
G
Connection contacts Cleaning W
D Daily
W Weekly
M Monthly
1/2 y Half-yearly
Y Yearly
Maintenance
intervals and
procedures
NOTE! Use a dry cleaning cloth to clean the machine components. Only
use a cleaning agent if this is indicated in the maintenance procedure for a
specic part.
G
G
C
E
Daily care:
After every use:
► Remove the welding carriage from the guide rail.
► Using a brush or a soft cloth, clean the guide rails for the oscillation unit, the guide
rollers and the gearbox.
► Carry out maintenance work as shown in the illustration below.
IMPORTANT! Do not use compressed air.