49
EN
Installation instructions for auto-transformers TPS
2700/TPS 5000/TIME 5000
Safety
WARNING!
Danger due to incorrectly performed work.
This can result in serious injury and damage to property.
► The following activities must only be carried out by trained and qualified personnel!
Take note of the safety rules in the power source operating instructions.
WARNING!
Danger from toppling welding machine.
A welding machine that topples over can easily kill someone.
► To ensure the centre of gravity is as low as possible, always fit the heavy autotrans-
former first (in the lowest position).
Fitting autotrans-
former
Fig.6 Detaching wirefeeder mount
Switch the power source mains switch
to the „O“ position
Pull out mains plug
Unscrew wirefeeder mount (F) from
the gas cylinder holder (E) (Fig.6)
Pivot wirefeeder mount (F) upwards,
unhook from the power source and re-
move (Fig.6)
Remove safety strap from the gas cy-
linder holder (E)
Fig.7 Attaching extension plate to gas cylinder holder
Place extension plate (2) onto gas cy-
linder holder (E) so that the eight holes
overlap (Fig.7)
Insert the enclosed „Extrude-Tite“
screws (3) into each of the two upper-
most and the two lowermost holes
(Fig.7)
– Note! The screws for fixing the ex-
tension plate to the gas cylinder
holder must be inserted in the di-
rection of the power source.
Screw the extension plate (2) to the
gas cylinder holder (E) using these four
screws (Fig.7)
To Next Page
Loading...
