51
EN
Fig.12 Inserting plug into socket
Pull the power source connector (H) as
far as possible through the opening on
the underside of the power source
(Fig.12)
Reconnect plug (G) between power
source and cooling unit (Fig.12)
Carefully place power source onto co-
oling unit (Fig.12)
Fasten power source to the cooling
unit at the front and back using socket
screws (Fig.12)
Fig.13 Trolley with auto-transformer, cooling unit and
power source
Attach wirefeeder mount (F) to the po-
wer source and lay down (Fig.13)
Fasten the wirefeeder mount (F) to the
extension plate (2) on the gas cylinder
holder (E) using four screws (Fig.13)
Fasten a safety strap to the extension
plate (2), level with the upper part of a
gas cylinder (not the neck of the cylin-
der)
(H)
(G)
(I)
Power source
Cooling unit
To Next Page
Loading...
