73
EN-US
Process:
Welding
Briefly lift the welding torch at the end of welding
The arc lengthens significantly.
Lower welding torch
- The arc shortens significantly
- The TIG Comfort Stop function has triggered
Maintain height of the welding torch
- The welding current continuously ramps down (DownSlope).
- The arc goes out.
IMPORTANT! The DownSlope is fixed and cannot be adjusted.
Lift welding torch from the workpiece
Break voltage
For setting a voltage value at which the welding process may be ended by slightly raising
the TIG welding torch.
The higher the break voltage value, the higher the arc can be raised.
The break voltage values for 2-step mode, 4-step mode, and operation with a foot-operat-
ed remote control are all stored together.
If the "tri" parameter (trigger - torch trigger operating mode) is set to "oFF", the values are
stored separately.
10 - 45 V
Factory setting: 35 V (for 2-step and 4-step mode and operation with a foot-operated re-
mote control)
Factory setting: 25 V (for trigger = oFF operation)
1
2
3
4 5
1
3
4
5
To Next Page
Loading...
Need help?
General
