Fax/Internet Fax Options
203
Fax
4
If you use a remote machine to perform secure polling for a folder on your machine,
give the following information.
F Code (sub-address) : 0 (to designate an F Code transmission) and the folder
number of the target folder
Password (if necessary) : The password of the target folder
Note • The DTMF method is available for Remote Folder. The supported signals are numerals, "∗",
and "#" only.
A file received in the folder can automatically be printed depending on the folder settings. For
information on the folder settings, refer to "Configuring/Starting Job Flow" (P.309).
Depending on the report print settings, a Folder Report may not be printed even after a file is received in
a folder. For information, refer to "5 Tools" > "Common Service Settings" > "Reports" > "Folder
Report" in the Administrator Guide.
For information on how to print files received in a folder, refer to "Printing Files in a Folder" (P.306).
Sending to Folder (F Code Method)
1 Select [F Code].
2 Select [On].
3 Select the [F Code] box, and enter an F code
using the displayed keyboard or the numeric keypad.
Note • You can enter up to 20 digits for the F code.
4 If necessary, select the [Password] box, and enter a password using the displayed
keyboard or the numeric keypad.
Note • You can enter up to 20 digits for the password.
Off
The F code transmission is not used.
On
The F code transmission is used. Enter the F Code.
F Code
Select the [F Code] box, and enter the F code using the displayed keyboard or the
numeric keypad.
Note • You can enter up to 20 digits for the F Code.
Password
Select the [Password] box, and enter the password using the displayed keyboard or the
numeric keypad. If a password is not set, leave this box blank.
Note • You can enter up to 20 digits for the password.
To Next Page
Loading...
