Broadcast
217
Fax
4
The following shows an example of F Code that indicates printing at the relay station,
notifying the initiating station (100) of the results, and performing Relay Broadcast to
relay recipients (200, 201, 202, and 203).
F Code example: 21100200201202203
5 If necessary, enter the password using the numeric keypad.
Remote Relay Broadcast (Performing Relay Broadcast to Remote Locations)
The Remote Relay Broadcast feature combines two or more Relay Broadcast
operations and use Broadcast Send.
This feature is more economical than Relay Broadcast in transmitting documents to
multiple remote machines.
Note • Multiple Relay Broadcast can be performed from a secondary relay station.
• For IP Fax (SIP), only Relay Broadcast with the F Code method is available.
The following three methods are available in Remote Relay Broadcast:
îš„Fax Signal Method
This method employs a Fuji Xerox proprietary communication procedure that is only for
use with specific machines that support the Relay Broadcast feature.
îš„DTMF Method
G3 fax machines that support Manual Send can perform Remote Relay Broadcast for
the machine.
îš„F Code Method
This method can be used among machines that support the F Code and the Relay
Broadcast features.
Fax Signal Method
Register the following information in the address numbers of initiating stations in
advance.
For information, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
For information on the setting items to be registered in a primary relay station and a secondary relay
station, refer to the documentations provided with them.
1 Select an address number or group dial number to which a remote relay broadcast is
registered, and press the <Start> button.
DTMF Method
The following two types are available in the DTMF method: Auto Send and Manual
Send.
Where Contents
Initiating
Station
Assign the relay station to an address number (0001 to 2000) to set up the
Relay Broadcast feature.
z
Register the last two digits of the address number of the initiating station
(which is already registered at a primary relay station) as a relay station ID.
z
Register the address numbers or group dial number of the secondary relay
stations (which are registered at a primary relay station) as broadcast
recipients.
To Next Page
Loading...
Need help?
General
