Broadcast
215
Fax
4
z
Password
A pre-registered 2-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support
Center. If a password is not set, you do not need to enter one.
z
Relay station ID
The last two digits of the initiating station address number registered at the relay
station
z
Address number
An address number for the relay recipients registered at the relay station
The wildcard "∗" can also be used.
You can register the above dialing format in an address number to send using the address number. For
information, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
2 Select [+ Add] to perform Multiple Relay Broadcast.
Note • You can specify up to 20 locations for relay recipients.
3 Press the <Start> button.
Manual Send (Transmitting with picking up the receiver or on-hook)
1 Select the [More Options] tab to display the [More Options] screen.
2 Pick up the telephone receiver, or select
[On-hook (Manual Send/Receive)].
3 Select [Manual Send] from the drop-down
menu.
4 Use the keyboard displayed on the touch
screen to enter numbers in the following
format.
Note • You can specify up to 20 locations for relay recipients.
F Code Method
You can perform Relay Broadcast by registering the relay station’s F code and
password (if necessary) to the machine.
Note • When performing Relay Broadcast with the F Code method, you can use a password if you
set a receive password for the relay station.
• When performing Relay Broadcast between Fuji Xerox manufactured machines that can be
used as both an initiating station and a relay station, we recommend that you use the fax
signal method.
To Next Page
Loading...
