EasyManua.ls Logo

Fuji Xerox DocuCentre-IV 3065 - Operations during Faxing

Fuji Xerox DocuCentre-IV 3065
633 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Connectivity & Network Setup
147
Tools
5
Important • Do not use a number that is the same as a port number of another port. However, you can
use the same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP
Discovery, SOAP, WebDAV, and Web Services on Devices (WSD)).
Note • [Added Port Number] cannot be configured if [Port Status] is set to [Disabled].
To configure [Added Port Number], enable port status and reboot the machine, and then
configure [Added Port Number].
EtherTalk
Port Status
Select [Enabled] to use EtherTalk.
Note • The Adobe PostScript 3 Kit (optional) is required.
Bonjour
Port Status
Select [Enabled] to use Bonjour.
Note • The Adobe PostScript 3 Kit (optional) is required to use the port. However, for Mac OS X
10.4.11 or later, you can use the port without the Adobe PostScript 3 Kit (optional).
• To print from a printer detected by [Bonjour], the LPD port must be activated in advance.
Port 9100
Port Status
Select [Enabled] to use Port9100.
Select this option when the communication protocol is in RAW format for Windows Standard
TCP/IP port monitor.
Port Number
Enter a port number for Port9100 from 1 to 65535.
The default value is 9100.
Important • Do not use the numbers assigned to the other ports.
SNMP
Port Status
Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji
Xerox to control the machine on the network.
SIP
Port Status
Enter [Enabled] for using SIP, when you use IP fax (SIP) transmission.
SIP Port Number
Set a port number to use IP fax (SIP).
The default value is 5060.
Important • Do not use any numbers assigned to other ports.
Note • IP fax (SIP) is not available for some models.
FTP Client
Port Status
Select [Enabled] when you use the Scan to PC service with FTP transmission.
Note • Select a communication mode to send data scanned via FTP from [Passive mode] and
[Active mode]. [Passive mode] is selected by factory default. You can change the setting
from CentreWare Internet Services
Downloaded From ManualsPrinter.com Manuals

Table of Contents

Other manuals for Fuji Xerox DocuCentre-IV 3065

Related product manuals