Fuji Xerox DocuCentre-IV 3065

Changing the Paper Settings
51
Paper and Other Media
2
Changing the Paper Settings
This section describes how to change the paper type for the Trays.
After loading paper in a tray, specify the type of paper loaded.
Note • You can change the paper type setting without entering to the System Administration mode
on the [Setup] screen, which is displayed by selecting [Setup] in the [Services Home] screen
if you configure the settings in advance. For more information, refer to "Customize Paper
Supply Screen" (P.120).
1 Press the <Log In/Out> button.
2 Enter the system administrator’s user ID with
the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next]
and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3 Select [Tools] on the [Services Home]
screen.
Note • When the [Services Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
4 Select [System Settings] > [Common
Service Settings] > [Paper Tray Settings].
5 Select [Paper Tray Attributes].
123
456
789
0#
C
<Log In/Out> button
Downloaded From ManualsPrinter.com Manuals