5 Tools
160
Tools
5
authenticating the remote server before a job startup, the machine performs verification at the
time of transmission with the remotely authenticated user name and password. You can also
select the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin using
System Data]. If you do not set remote authentication, the machine uses the user ID and
passcode of the machine for authentication.
îš„SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
îš„SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
Note • If you do not set the password, leave the text boxes blank and select [Save].
Remote Authentication/Directory Service
You can make the settings for the remote authentication server and directory service.
Authentication System Setup
îš„Authentication System
Allows you to select the authentication system from [Kerberos (Windows 2000)], [Kerberos
(Solaris)], [LDAP], and [SMB], and [Authentication Agent].
After you change the authentication system, personal folders and personal sheets used with
the previous authentication system are not deleted automatically. If these folders or job flow
sheets are no longer needed, delete them from the machine. If the same user IDs are also
used on the new authentication system, personal folders and personal job flow sheets can be
used by the same users.
îš„Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
îš„Search Time-Out
Set the user information search time-out between 1 and 120 seconds in 1 second increments.
Kerberos Server Settings
Configure the Kerberos Servers 1 to 5.
The settings in [Kerberos Server 1 (Default)] will be the default settings for authentication.
îš„Primary Server Name/Address
Enter the primary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
îš„Primary Server Port Number
Set the primary server port number from 1 to 65535.
The default value is 88.
Important • Do not use the numbers assigned to the other ports.
îš„Secondary Server Name/Address
Enter the secondary server name or IP address.
Note • For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
• For IPv6, enter the address in the format "xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where
"xxxx" is a hexadecimal value.
îš„Secondary Server Port Number
Set the secondary server port number in the range from 1 to 65535.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
