5-40
5.3 Print Condition Setup and Check (02)
This procedure sets the paper condition setup
method.
[Selection]
[Setup and Maintenance] → [02 Print Condition Setup
and Check] → [0242 Paper Condition Method Setup]
1. Select “YES” or “NO” for the ambient variable
correction.
2. Select “YES” or “NO” for the master magazine
registration.
3. If “YES” is selected in Step 2, set the ID, width,
paper and type for the master magazine.
NOTE: • Ambient variable correction: When there is a
sudden change in temperature during the day,
it influences the color development process of
color papers. To maintain constant printing
quality in that condition, select “YES”.
• Master magazine registration: Paper condition
setup must be performed for all papers if “NO”
is selected.
4. Click the [Next Page] button.
5. Enter “Density correction value” for “Patch No.”
and “Temperature correction value” of the AD300
densitometer, if necessary.
6. Click the [Set] button.
7. Click the [OK] button.
• Operation returns to the menu screen.
5.3.12 Paper Condition Method Setup (0242)
↓ [Next page] [Prev page] ↑
Distributed by minilablaser.com
To Next Page
Loading...
Need help?
General