FujiFilm SP-3000 - LED23 Circuit Board Replacement

8-7
8.1 Light Source Section
8
Removal
1. Remove the light source assembly
(See Subsection 8.1.4).
2. Remove the four screws and then the transparent
cover.
3. Remove the filter and gasket.
4. Disconnect the four connectors from the LED23
circuit board.
8.1.6 LED23 Circuit Board Replacement
Z2170
Screws (4)
Transparent Cover
Z2169
Filter
Gasket
Z2171
LED23 Circuit
Board
LED1 Connector
LED2
Connector
LED4 Connector
LED3 Connector
Distributed by minilablaser.com