13-15
13.1 Distribution Entrance Unit
13
Removal
1. Remove the distribution entrance unit
(See Subsection 13.1.4).
2. Disconnect the connector from the sensor.
3. Release the locking tabs then remove the sensor.
Installation
Installation is essentially in the reverse order of removal.
Removal
1. Remove the distribution entrance unit
(See Subsection 13.1.4).
2. Loosen the two screws and remove the timing belt.
Installation
Installation is essentially in the reverse order of removal.
NOTE: • Install the tension adjustment spring then tighten
the two motor screws.
• If there is no spring at the M656 side, it is installed
in the M655 side. Remove it and use to adjust belt
tension.
13.1.9 Nip Release Home Position Sensor 3 (D656) Replacement
LII501
Connector
Locking Tabs
Sensor (D656)
13.1.10 Nip Release Timing Belt (M656 Side) Replacement
LII502
Screws (2)
Belt
LII503
Spring
Screws (2)
Distributed by minilablaser.com
To Next Page
Loading...
Need help?
General