FujiFilm SP-3000 - Lower Cutter Feed Roller Replacement

11-18
11.1 Cutter/Feed Section
3. Remove the two E-rings, two bearings and then
the roller.
Installation
Installation is essentially in the reverse order of removal.
Removal
1. Remove:
• Motor bracket
(See Subsection 11.1.7).
• Upper cutter unit
(See Subsection 11.1.12).
•Lower cutter unit
(See Subsection 11.1.15).
2. Remove the four screws and then the connector
bracket.
3. Remove the E-ring and then the bearing.
LII056
E-rings (2)
Bearings (2)
Roller
11.1.18 Lower Cutter Feed Roller Replacement
LII057
Screws (4)
Connector Bracket
LII058
E-ring
Bearing
Distributed by minilablaser.com