99
5.5 [Network Settings]
[Security Settings]
[SSL/TLS Settings]
Set when encrypting communication between the machine and servers or client computers.
Item Description
[TLS Security Level] Sets the mode of encrypted communication.
[Device Certificate - Server] Sets server certificate for SSL/TLS communication.
[HTTP - SSL/TLS
Communication]
Enables use of SSL/TLS communication only.
Note
If set to [Enable HTTPS Only], the ports for [UPnP Discovery] and
[WSD] are stopped.
[HTTP - SSL/TLS Port
Number]
Specifies port number for SSL/TLS communication.
[LDAP - SSL/TLS
Communication]
Enables SSL/TLS communication for accessing authentication,
search, etc.
To enable SSL communication, it is necessary to change [Primary
Server - Port Number] and [Secondary Server - Port Number] for
[LDAP Server / Directory Service Settings]. The port number for SSL
communication of the LDAP directory server is ordinarily 636.
[SMTP - SSL/TLS
Communication]
Sets settings for SSL/TLS communication.
[Disabled] SSL/TLS communication is not performed.
[STARTTLS (If
Available)]
Performs SSL/TLS communication after verifying certificate. SSL/TLS
communication is not performed if certificate cannot be verified.
[STARTTLS] Performs SSL/TLS communication after verifying certificate.
Communication is not performed if certificate cannot be verified.
[SSL/TLS] Performs SSL/TLS communication.
[ThinPrint - SSL/TLS
Communication]
Enables SSL/TLS communication.
[Device Certificate - Client] Sets client certificate for performing SSL/TLS communication.
[Verify Remote Server
Certificate]
Enables verification of remote server certificate when operating the
machine as an SSL client.
To Next Page
Loading...
Need help?
General
