Working with the no tebook
Connecting the mains a dapter to the Port Replicator
3
1
2
► Connect the power cable to t he
mains adapter (1).
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the D C
jack (DC IN) of the Port Replicator (3).
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This pro file will be loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the ON/OFF switch on the port
replicator to switch the notebook on.
The power-on indicator of the Port
Replicator lights up .
Switchin
g off notebook via Port Replicator
► C lose all applications an d shut down your op erating system (please refer
to the manual f or the operating system).
If the notebook cannot be shut down properly, press the ON/OFF button
on th e Port Replicator for approx. four seconds. The notebook will switch
off. Any unsaved data may however be lost.
44 Fujitsu
To Next Page
Loading...
