Fujitsu DL3100 User Manual

FUJITSU DL3100
5-8 User’s Manual
Paper Setup
Valid Settings
Function
Bail mode
Invalid, Standard, Special
The bail mode presses the paper
against the print platen during
printing, but it is released for paper
loading.
Invalid: If you uninstall the lever or
want to disable the function, set this
setting to “invalid”.
Standard: Release the lever for paper
loading and lower the lever to press
the paper against the platen during
printing.
Special: When the paper is in
tear-off position, after the printer
received printing data, the printer
will judge whether tear-off was
implemented first. If tear-off was
implemented and printing position is
in lever area, then the printer will
press the lever; If tear-off was not
implemented, the printer will not
press the lever.
Roll Paper
No, Yes
In friction mode, [LF/FF] will not
eject the paper and feed to next
page. (Assume roll paper)
Single LF Adj
Level+D, Level+C,
Level+B, Level+A,
Normal, Level-A,
Level-B, Level-C,
Level-D, Graphic
Set the line feed correction quantity
for single paper. (Correct the line
feed deviation when the line feed is
approximately 1 inch. If the printing
position deviates in the upward
direction, correct it in the +
direction.)
Regarding the correction quantity, A
is larger than D.
NOTE:
The Restore function cannot reset
those options which are handled by
the Single LF Adj settings.
Single LF Adj is correct when
shipped.

Fujitsu DL3100 Specifications

General

Brand	Fujitsu
Model	DL3100
Category	Printer
Language	English