ErgoPro e-, x- and s- Series PC Specialist's Handbook
Page 52 First Edition, Release 4 - June 1998
BIOS(34): Keyboard error
During reset, the keyboard returned an unknown identity code. Have the keyboard replaced.
BIOS(35): Keyboard error
No response from keyboard after reset command.
BIOS(40): System board Parity Error. Address = <xxxx xxxx> H.
An error at address <xxxx xxxx> H on the system board has been detected.
BIOS(41): Expansion Memory Parity Error.
Address = <xxxxxxxx> H.
An error at address <xxxx xxxx>H on an expansion board has been detected.
BIOS(50): Floppy error, status = codeH
When resetting the diskette controller, BIOS returned an error code. If this message persists,
you will need a new diskette drive, disk controller, floppy cable or a processor board.
BIOS(60): Hard disk controller error, status = codeH
The disk controller reset failed. If this message persists, the fixed-disk controller must be
replaced.
BIOS(61): Hard disk controller error, status = codeH
Internal diagnostics failed. If this message persists, the fixed-disk controller must be replaced.
BIOS(62): Hard disk number failure, status = codeH
An INIT DRIVE or RECALIBRATE DRIVE command failed. The number indicates the
concerned fixed disk (0 = first disk,1 = second disk). If this message persists, the fixed disk
must be replaced.
BIOS(63): Hard disk number failure, status = codeH
An attempt to read a sector on the innermost cylinder failed. The number indicates the
concerned fixed disk (0 = first disk,1 = second disk). This message might be caused by an
error in the set-up parameters. Check the parameters in SETUP. If the message persists, the
fixed disk must be replaced.
BIOS(70): Boot load failed. System stopped.
An INT18 was issued during the loading of the operating system Either there is a device
hardware failure, or the program is not designed for use on an AT-type system unit.
BIOS(74): Boot failure Unable to boot from medium 1 (x)
Unable to boot from medium 2 (x)
Unable to boot from medium 3 (x)
System halted.
Instead of one or more lines reading Unable to boot from medium x, the following line may be
displayed :
Boot medium x not specified.
In the message, "x" stands for a diskette drive, fixed disk or network. The system boot up
failed on account of any of the following reasons:
A system diskette is not fully inserted in drive A. Check that the diskette is properly inserted.
If the diskette in drive A: is not a system diskette, replace the diskette with a system diskette.
The diskette-drive controller may be disabled. If your system has a system-board diskette-
drive controller, set the values of the Floppy controller parameter in the Admin-Security
screen to Read only or Read/Write.
If the fixed disk is damaged, have your system unit serviced. If the fixed disk has no operating
system, install the operating system.
The fixed-disk controller may be disabled. Check the value of the Hard disk 0 parameter in
the Admin-Config menu to see that it reflects the type of fixed disk installed.
Your system may have an incorrect boot PROM. If this is the cause of the problem, have your
system serviced.
Your workstation might not be connected to the network. Connect the network cable.
If the LAN adapter is configured incorrectly, re-configure the adapter.
If the network is down, contact your system administrator.
To Next Page
Loading...
Need help?
General