The following procedure shows an example when selecting the [IPv4 Settings] tab.
2 Set up the SNMP environment.
(1) On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
(2) In [Category], click [Network].
The [Network] screen appears.
(3) In [Action], click [Setup SNMP Interface].
The [Setup SNMP Agent Basic Interface] screen appears.
(4) Select [Enable] for [SNMP Function], set the required items, and click the [Set] button.
Select the LAN port that was set up in Step 1 for "LAN Port used for SNMP".
A confirmation screen appears.
Chapter 6
Monitoring Settings
6.2 Various Notification Settings
103
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
