Fujitsu ETERNUS DX100 S3 - Server Connection Setup; Iscsi Initiator Parameter Settings (Connection Information Settings); Figure 8.1 Connection Configuration with Servers

8.2 Server Connection Setup
Set up the server as required to connect to the ETERNUS DX Disk storage system.
The IP address to connect to the iSCSI network must be set on the server before the ETERNUS DX Disk storage
system is connected.
After the server connection setup is completed, confirm that the volumes in the ETERNUS DX Disk storage
system can be recognized by the server.
Figure 8.1 Connection Configuration with Servers
iSCSI multipath
connection
Server (host)
ETERNUS DX
Disk storage system
LAN card#0
A
LAN card#1
B
CA#0 Port#0
C
CM#0
CA#0 Port#0
D
CM#1
8.2.1 iSCSI Initiator Parameter Settings (Connection Information Settings)
Use the iSCSI Software Initiator to set the iSCSI initiator parameters.
After performing the settings, check the connection to the ETERNUS DX Disk storage system.
Turn on the ETERNUS DX Disk storage system while its iSCSI port is connected to the LAN port for iSCSI con-
nection on the server with the host interface cable. After confirming that the ETERNUS DX Disk storage sys-
tem is in READY status, turn on the server.
1 On the [iSCSI Initiator Properties] screen, click the [Discovery] tab.
Chapter 8
SAN Connection Settings
8.2 Server Connection Setup
135
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0