Fujitsu ETERNUS DX100 S3 - Figure 5.8 RAID Group Information after Creation

7 After creating an operation RAID group, repeat Step 1 and later steps to create a backup RAID group.
The following screen shows the settings that are displayed when creating a RAID group with the RAID
group name "RG1" and the RAID level "RAID5(2+1)".
The following screen shows the RAID group information that is displayed after the RAID group is created.
Figure 5.8 RAID Group Information After Creation
Chapter 5
General Settings
5.7 RAID Configuration Settings
91
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0