9.1.3 Copy Parameter Settings
Set the parameter and the area allocation unit (SDPE) to execute notification automatically when the SDP
capacity becomes insufficient while SnapOPC+ is running.
The following four types of notification methods are available: Email, SNMP, Trap, and Syslog. The method
that is specified in "6.1 Event Notification Setup" (page 101) is used as the notification to the user. Specify
whether to enable notification and the notification method when enabled in advance.
If the data to be copied exceeds the physical capacity of the copy destination (if no SDP with free space
exists), the copy session and the copy sessions of earlier generations cause an error.
Notification occurs only once for each policy level. No notification is sent even if the threshold is reached
within 24 hours from the previous notification. Notification is sent after 24 hours have passed.
When the thresholds of multiple levels are reached at the same time, the highest level of notification is
sent.
1 Click the [Advanced Copy] tab on the navigation of the ETERNUS Web GUI screen. Then, click [Snap Data
Pool] in [Category].
2 In [Action] on the [Setting] screen, click [Modify Copy Parameter].
3 Set the required items and click the [Set] button.
4 In the confirmation screen, click the [OK] button.
Copy table size setting starts.
Chapter 9
Advanced Copy Settings
9.1 Advanced Copy Basic Settings
161
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
