EasyManua.ls Logo

Fujitsu ETERNUS DX100 S3 - Figure 1.4 Rear Views of a Controller Enclosure (When Two Controllers Are Installed)

Fujitsu ETERNUS DX100 S3
188 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When two controllers are installed
There are two types of configurations that correspond to the combination of host interfaces.
Figure 1.4 Rear Views of a Controller Enclosure (When Two Controllers are Installed)
12
34 5 6 34 58
9
10
7 687
1. Controller (CM#0)
2. Controller (CM#1)
3. PWC port
4. Host interface (CA#1)
5. Drive interface (OUT) port
6. LAN (RMT) port
7. LAN (MNT) port
8. Host interface (CA#0)
9. Power supply unit (PSU#0)
10. Power supply unit (PSU#1)
12
34 56 7 6 734 588
9
10
1. Controller (CM#0)
2. Controller (CM#1)
3. PWC port
4. Host interface (CA#0)
5. Drive interface (OUT) port
6. LAN (RMT) port
7. Host interface (CA#1)
8. LAN (MNT) port
Chapter 1 Component Names
1.1 Controller Enclosures
20
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0

Table of Contents

Other manuals for Fujitsu ETERNUS DX100 S3

Related product manuals