Fujitsu ETERNUS DX100 S3 - Temporary Work Volume (SDPV) Creation; Figure 5.11 Temporary Work Volume (SDPV) Creation

*2: If "7" is specified for the number of volumes, sdv0, sdv1, sdv2, sdv3, sdv4, sdv5, and sdv6 volumes
are created.
A confirmation screen appears.
4 Click the [OK] button.
The volume is created and the registration completion screen appears.
5 Click the [Done] button.
The screen display returns to the [Volume] screen.
5.7.4 Temporary Work Volume (SDPV) Creation
Create a temporary work volume in the backup RAID group.
Create a volume as an expansion area of SDV in the backup RAID group "RG1" created in "5.7.1 RAID Group
Creation" (page 88).
Figure 5.11 Temporary Work Volume (SDPV) Creation
500GB
2TB
2TB
2TB
Temporary work volume
sdpv
(Snap Data Pool Volume)
Backup RAID group (RG1)
RAID5 (2+1)
Chapter 5
General Settings
5.7 RAID Configuration Settings
95
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0