Fujitsu ETERNUS DX100 S3 - Powering on; Switching on and off the Main Line Switch on the Power Distribution Unit; Figure 5.3 PC Terminal Connection for Initial Setup; Figure 5.4 on Position (Marked |) of the Main Line Switches on a 1 U Power Distribution Unit

The ETERNUS DX Disk storage system and the PC terminal must be connected directly since the network
environment of the ETERNUS DX Disk storage system is set using the PC terminal for the initial setup of
the ETERNUS DX Disk storage system.
Figure 5.3 PC Terminal Connection for Initial Setup
PC terminal
LAN cable
LAN port
Controller
enclosure
RMT port of Controller 0 (CM#0)
5.2 Powering On
This section explains how to turn on the ETERNUS DX Disk storage system.
5.2.1 Switching On and Off the Main Line Switch on the Power Distribution Unit
Turn the main line switch of the power distribution unit to the ON position (marked "|").
Make sure all of the main line switches are in the ON position.
● For 1U
Figure 5.4 ON Position (Marked "|") of the Main Line Switches on a 1U Power Distribution Unit
Main line switch
Chapter 5
General Settings
5.2 Powering On
73
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0