•
Do not uninstall the drives that are installed by default or move them to any other
slot.
Contact your sales representative or maintenance engineer if drives that are instal-
led by default need to be uninstalled or moved to another slot.
The procedure to register a RAID group is as follows:
1 On the navigation of the ETERNUS Web GUI screen, click the [RAID Group] tab.
The [RAID Group] screen appears.
2 In [Action], click [Create].
The [Create RAID Group] screen appears.
3 Enter the name of the RAID group that is to be registered. Select "Manual" for "Create Mode".
Chapter 5
General Settings
5.7 RAID Configuration Settings
89
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
