2 In [Target portals], click the [Discover Portal] button.
3 In [IP address or DNS name] on the [Discover Target Portal] screen, specify the IP address of "CM#0
CA#0 Port#0" of the ETERNUS DX Disk storage system (C in Figure 8.1).
When the port number on the ETERNUS DX Disk storage system is changed, the value set in [Port] must
be changed.
4 Click the [Advanced] button.
5 On the [Advanced Settings] screen, click the [General] tab.
6 Specify the following items under [Connect using].
Local adapter: Microsoft iSCSI Initiator
Initiator IP: IP address of the server (A in Figure 8.1)
When setting access restrictions, the settings related to CHAP authentication is required.
For details on CHAP authentication, refer to "Configuration Guide -Server Connection-".
Chapter 8
SAN Connection Settings
8.2 Server Connection Setup
136
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
