Fujitsu ETERNUS DX100 S3 - Page 122

Settings for the power control functions How the ETERNUS DX Disk storage system operates
Auto Power function is enabled
Power Resume function is enabled
The ETERNUS DX Disk storage system is automatically
turned on when AC power is supplied and when power
is restored after a power failure.
The procedure to enable the Auto Power function and/or the Power Resume function is described below.
1 On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2 In [Category], click [System Settings].
The [System Settings] screen appears.
3 In [Action], click [Setup Power Management].
The [Setup Power Management] screen appears.
4 In the [Setup Power Management] screen, select [Enable] for [Auto Power], [Power Resume], or both.
5 Click the [Set] button.
A confirmation screen appears.
6 Click the [OK] button.
The Auto Power function and/or the Power Resume function setting is applied.
7 Check the setting completion message and click the [Done] button.
The screen display returns to the [System Settings] screen.
Chapter 7
Power Control Setup
7.1 Setup of the Auto Power Function and/or the Power Resume Function
122
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0