12 Confirm that the ETERNUS DX Disk storage system iSCSI name is displayed in [Discovered targets] and
that the [Status] is [Inactive].
13 Select the iSCSI name that is to be the connection target, and click the [Connect] button.
In this example, "CM#0 CA#0 Port#0" with an iSCSI name that is specified in "8.1.2.2 iSCSI Port Parame-
ter Settings" (page 128) is the target.
[Connect To Target] appears.
14 Confirm the controller number at the end of the target name and click the [Advanced] button.
15 On the [Advanced Settings] screen, specify the following items under [Connect using] and click the
[OK] button.
Local adapter: Microsoft iSCSI Initiator
Initiator IP: IP address of the server (A in Figure 8.1)
Chapter 8
SAN Connection Settings
8.2 Server Connection Setup
140
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
