Fujitsu ETERNUS DX100 S3 - Page 155

Perform the settings as shown below.
Drive
File system
that is to be
created
LUN Volume No.
Volume
name
Type Capacity (*1)
G RAW 1 1 sdv0 SDV (1TB)
H RAW 2 2 sdv1 SDV (1TB)
I RAW 3 3 sdv2 SDV (1TB)
J RAW 4 4 sdv3 SDV (1TB)
K RAW 5 5 sdv4 SDV (1TB)
L RAW 6 6 sdv5 SDV (1TB)
M RAW 7 7 sdv6 SDV (1TB)
*1: The capacity that is displayed in "( )" is the copy source capacity.
5 Select [Do not format this volume], and click the [Next] button.
6 [Completing the New Simple Volume Wizard] appears. Click the [Finish] button.
Chapter 8
SAN Connection Settings
8.2 Server Connection Setup
155
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0