Fujitsu ETERNUS DX100 S3 - Page 173

• After power-off, wait for about one minute before turning power on again.
• If the Power switch is pressed again between the time of the READY LED ( ) turning off and the
POWER LED ( ) turning off, the ETERNUS DX Disk storage system power may turn on.
2 The ETERNUS DX Disk storage system power is turned off.
The POWER LED ( ) of the controller enclosure and the POWER LEDs ( ) of the drive enclosures are
turned off.
■
When a Power Synchronized Unit is Used
If the server is turned off, the ETERNUS DX Disk storage system is also turned off.
Chapter 10 System Status Check
10.6 Powering Off
173
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0