Fujitsu ETERNUS DX100 S3 - Page 31

2 Install the power distribution unit in the rack.
Fasten it to the prepared holes in the pillars with eight M5 screws.
(Rack pillar: rear)
M5 screw
M5 screw
3 Attach the blank panel to the rack front.
The blank panel should be attached at the same height as the power distribution unit.
(Rack pillar: rear)
(Rack pillar: front)
Blank panel
Power distribution unit
Chapter 2 Rack Installation
2.1 Installing Power Distribution Unit (for Regions Other than EMEA&I)
31
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0