Fujitsu ETERNUS DX100 S3 - Page 42

6 Fasten the high-density drive enclosure in the rack.
Use four M5 screws to fasten it in the rack.
(Rack pillar: front)
(Rack pillar: rear)
M5 screws
M5 screws
7 Attach the cable management arm.
To attach the cable management arm, place the arm in the bracket on the rear of the high-density
drive enclosure. After placing the arm in the bracket, firmly attach the arm with the pin.
Cable
management arm
Pin
Chapter 2
Rack Installation
2.4 High-density Drive Enclosure Installation (for Regions Other than EMEA&I)
42
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0