4 The currently set initiator name is displayed.
Click the [Change] button.
5 On the [iSCSI Initiator Name] screen, specify the initiator name and click the [OK] button.
To leave the initiator name unchanged, click the [OK] button.
To use the default initiator name, also click the [Change] button.
This allows you to continue to use this initiator name even after changing the "server name".
Chapter 3
Checking the Configuration Environment
3.2 Server Connection Preparation
49
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
To Next Page
Loading...
