Fujitsu ETERNUS DX100 S3 - Page 57

The following procedure explains how to connect the cable between enclosures.
•
To help with management of the cable between enclosures and prevent incorrect connections, make
sure to attach the destination labels to the connectors of the cables.
•
When connecting the cable between enclosures, check the direction of the connector and insert it all the
way in firmly.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
Pull-tab
When high-density drive enclosures are installed, fasten the high-density drive enclosure cable between
enclosures with the clamp belts to the flap brackets and the cable management arm on the rear of the
device.
Clamp belts
Clamp belts
Flap bracket
Cable management arm
Chapter 4
Connecting Cables
4.2 Drive Enclosure Connection
57
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0