Fujitsu ETERNUS DX100 S3 - Page 87

5 In the [Setup Firewall] screen, specify whether to enable/disable each service.
To enable a service, select the checkbox for that service.
• HTTP connection/HTTPS connection
This service is enabled when an ETERNUS DX Disk storage system is connected via ETERNUS Web GUI.
Data is encrypted and transferred for HTTPS.
• Telnet connection/SSH connection
This service is enabled when an ETERNUS DX Disk storage system is connected via ETERNUS CLI.
Data is encrypted and transferred for Secure SHell (SSH).
• ICMP
This service is enabled when an ICMP connection is allowed.
• Maintenance Secure
This service is enabled for connections from things such as monitoring software or for using the re-
mote support function to download firmware between storage systems.
SSH encrypts and sends/receives data.
• SNMP
This service is enabled when an ETERNUS DX Disk storage system is connected via the SNMP manag-
er.
• RCIL
This service is enabled when an RCIL Power Synchronized Connection is used.
• ETERNUS DX Discovery
Change the setting to "Disable".
6 Click the [Set] button.
7 In the confirmation screen, click the [OK] button.
The firewall settings are applied.
Chapter 5
General Settings
5.6 Firewall Settings
87
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0