Fujitsu ETERNUS DX100 S5 - Figure 142 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Only One Controller)

● Rear View
Figure 142 Rear View of a Controller Enclosure (When the ETERNUS DX60 S5 Is Installed with Only One
Controller)
1
2 4 5 63
8 8
PSU#0 PSU#1
CM#0
7
1 Controller (CM#0)
(Refer to "Controllers" (page 257
).)
2 PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to "■ PWC Ports" (page 263).)
3 Host interface
This interface is used for connecting a controller with a server.
(Refer to "■ Host Interfaces" (page 259).)
4 Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to "■ Drive Interface Ports" (page 263).)
5 RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)
6 MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)
7 Cover
Remove this when installing an additional controller (optional).
8 Power supply unit (PSU#0, PSU#1)
(Refer to "■ Power Supply Units" (page 264).)
6. Hardware Configurations
Controller Enclosure
247 Design Guide