Fujitsu ETERNUS DX100 S5 - Figure 147 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5;DX200 S5 Is Installed with Only One Controller)

To Next Page

To Previous Page

Figure 147 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with

Only One Controller)

1 1

2 4 5 3 5 32 3 46 6

PSU#0 PSU#1

CA#0

CM#0 CM#1

CA#1 CA#0 CA#1

1 Controller (CM#0, CM#1)

(Refer to "Controllers" (page 257

).)

2 PWC port

This port is used to connect a power synchronized unit with an RS232C cable.

(Refer to "■ PWC Ports" (page 263).)

3 Host interface (CA#0, CA#1)

(Refer to "■ Host Interfaces" (page 259).)

4 Drive interface (OUT) port

This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable

between enclosures.

(Refer to "■ Drive Interface Ports" (page 263).)

5 RMT (LAN) port

This port is used for connecting a LAN cable. Use this port to separate the network (such as for the

remote support) from the MNT port for operation management. This port uses an RJ-45 connector.

(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)

6 MNT (LAN) port

This port is used for connecting a LAN cable and used for operation management. This port uses an

RJ-45 connector.

(Refer to "■ MNT Ports/RMT Ports/FST Ports" (page 263).)

7 Power supply unit (PSU#0, PSU#1)

(Refer to "■ Power Supply Units" (page 264).)

6. Hardware Configurations

Controller Enclosure

251 Design Guide

Other manuals for Fujitsu ETERNUS DX100 S5